Got more toys
- Thread starter BlackedOutHemi
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
truckin151
Supporting Member
Just remeber if there is a defect with the raceland setup and it came that way from them, they replace it for free, if you **** it up, fry the motor, etc. from crossing wires around and "playing with it" then you are out time and money and have to buy a new kit.
OP
OP
BlackedOutHemi
Senior Member
- Joined
- Feb 27, 2011
- Posts
- 5,454
- Reaction score
- 196
- Location
- DFW, Texas
- Ram Year
- 2012 & 2012
- Engine
- 5.7L HEMI & 6.7L Cummins
it's not messed up, and actually works perfectly fine. Just would like a switch in the cab rather than the remote.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
05singlecabHEMI
Senior Member
how did you wire it? any pics?
i was thinking of coming from behind the cab straight into the lower port under the ashtray sot its straight in and only shows about 1foot of wireing.
i was thinking of coming from behind the cab straight into the lower port under the ashtray sot its straight in and only shows about 1foot of wireing.
05singlecabHEMI
Senior Member
can only be used on the 5.7s. but i love it! mainly because of the oldschool look to it. but the performance is definitely there!
Oh ok makes sence
blackout11
Senior Member
- Joined
- May 23, 2011
- Posts
- 4,000
- Reaction score
- 451
- Location
- alpharetts GA
- Ram Year
- 2011 R/T
- Engine
- hemi 5.7
will that intake fit a 2011 if so u got a link
blackout11
Senior Member
- Joined
- May 23, 2011
- Posts
- 4,000
- Reaction score
- 451
- Location
- alpharetts GA
- Ram Year
- 2011 R/T
- Engine
- hemi 5.7
for the cut out do you just unbolt the factory pipe and slip that in place or is there mods needed to be done
truckin151
Supporting Member
The vararam? No, not yet anyways think they are still in the test fitting phase
Yes and no, you need to free up about a foot of pipe to put the cutout on. so theoretically you could unbolt the system from the y pipe back move everything back enough and slide it in and clamp it in. Or you could undo the muffler and do it. Really not to sure how much room you have to budge. I just cut a section out and welded it in and put in a turn down tip.
