BoDuke
Senior Member
I just want to start out saying the information on this site is incredible and the knowledge of the members has been so helpful and i hope this post can ad to the vast amount of information! But here I go, This past weekend I picked up a throttle body and intake for my 360, I am planning on doing the kegger mod with taking the throttle body's air horns off and taking the inside diameter the .004 thousandths to a true 50 millimeter bore. ..
Here is the throttle body and intake before anything was done
Heres the throttle body after cleaning and disassembly ... I had read alot of people had problems taking the butterfly bolts out so i took extra care removing them and had no issues i aslo used a rubber mallet to knock the rod that holds the butterflies out
This is where i have a question ... What is this small hole on the top of the throttle body? it had a small screw in it.
And also how bad does this plenum gasket look?
The further i get into this mod the more pictures and steps i took i will post and any problems i run into
Here is the throttle body and intake before anything was done
Heres the throttle body after cleaning and disassembly ... I had read alot of people had problems taking the butterfly bolts out so i took extra care removing them and had no issues i aslo used a rubber mallet to knock the rod that holds the butterflies out
This is where i have a question ... What is this small hole on the top of the throttle body? it had a small screw in it.
And also how bad does this plenum gasket look?
The further i get into this mod the more pictures and steps i took i will post and any problems i run into