My 84 prospector

[ramanator]

Anyone know a good way to get plasti dipp off

 

[dodge dude94]

Depends on how thick it is

 

[ramanator]

Not thick enough to peel it off

 

[dodge dude94]

Scrubber it? lol

 

[crazzywolfie]

used motor oil usually take off any paint that is not oil and gas resistant. may or may not work on plastic dip.

 

[ramanator]

Need to try something because it isn't peeling right off like its suppost to

 

[dodge dude94]

Take a scrubby pad to it with soapy water.

 

[ramanator]

I'll try that when I get home if it ain't raining. I know one thing I'll never do a entire vehicle again with plasti dipp

 

[dodge dude94]

Or at least do it thicker.

 

[ramanator]

Well got most of the dip off today. Finally lol maybe can get the rest tomorrow

 

[ramanator]

New problem. It's been sitting awhile so I drove it around Saturday and the longer I drove it the worse it got. It started acting like it wasn't getting gas and just got worse till it died. So I changed the fuel filter but it didn't help. So today I changed the coil and drove it down the road and it did the same thing. So does anybody have a clue what's the problem

 

[crazzywolfie]

Could possibly have a bad fuel pump

 

[ramanator]

I hope that's all it is lol are they hard to change on these trucks

 

[crazzywolfie]

they are usually not too bad to change. they are on the passenger side of the block under the alternator

 

[ramanator]

Thanks just call autozone and it's about 20 bucks might tackle that tonight

 

[ramanator]

Me and my dad got the new fuel pump installed and now the truck doesn't have any spark.

 

[crazzywolfie]

have you checked the distributor cap? also are you grounding the spark plugs when cranking the engine? if they are not ground you will not see any spark.

 

[ramanator]

My dad grounded it. He's a certified dodge mechanic. He just didn't have a lot of his tools to check everything out. He said it might be the distributor cap. I'm trying to help him out he's got a lot on his plate to mess with my problems lol

 

[crazzywolfie]

pulling the distributor cap to inspect things is fairly easy. just 2 clips holding it on.

 

[ramanator]

pulling the distributor cap to inspect things is fairly easy. just 2 clips holding it on.

Thanks I'll check it when I get home