Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Unfortunately not yet. Still bouncing around in the bed till I get that squared away. May still mount up a swing arm on the bumper for it since I do plan on building a rack over the bedDecide on a solution for the tire?
Sent from my SM-N920V using Tapatalk
Same here. It been in the bed for 2 years.Unfortunately not yet. Still bouncing around in the bed till I get that squared away. May still mount up a swing arm on the bumper for it since I do plan on building a rack over the bed
I saw that one but I think I want a sideways swing similar to a Jeep setup. Just like this but mounted to the bumper. I’ve got a few ideas since I’m looking at adding gussets internally to the bumper and adding some D rings as well close to the frame area for recovery. Will be reinforcing the bumper mounting bracket and welding it solid to the bumper as well for a more solid bumper. It’ll be a lot of work but I can’t find an aftermarket bumper for the rear that I really likeSame here. It been in the bed for 2 years.
Move bumpers has a diy kit for a swing out. Might be able to make it work. I've been toying with similar myself. https://www.movebumpers.com/products/classic-series-swing-out-tire-carrier-kit
With some tweaking I think you could make a mount that goes to the frame pretty easily.
Sent from my SM-N920V using Tapatalk
Which flares are these? I like the looks of them...perfect width for what I need.
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/233389351946Which flares are these? I like the looks of them...perfect width for what I need.
They are not bedlined. I purchased flares that are a textured black finish. Was going to get some bedlined but waiting to see if I find other flares off a 2500 first. These were cheap so I went for it as a temporary coverage. 220 shipped.Never saw your reply in regards to rear bumper. There's so many ways to add a tire carrier. Just takes some time....alot of time actually.
Flares look good! Hard to see exact detail but are they bedlinered?
Sent from my SM-N920V using Tapatalk
Removed my tow hooks temporarily. This bumper reuses the stock tow hooks which is awesome. Good thing I saved the stock tow hook brackets. Going to be a big difference especially on approach angles. I ordered the skid plate attachment too. It attaches to the lower tow hook mounting point and to the bottom of the bumper itself. Will post pictures of install and finish next week as I’m to busy this week. Need to order some pod lights. Looking for a yellow flood to install to use as fog lights