truckin151
Supporting Member
Now it was not my intention to destroy the thing BUT in trying to get it off I came to the realization that even if you get past the glue along the edges (which does not come off with a heat gun....tried it) the whole assembly is basically one piece. Frog I know you would be somewhat interested so here are some pics:
Also to add, if you were to do this to block off al the chambers to make it a through and through design, the best bet (and my first thought) was to cut the pipe on the underside of the hat and plug the holes up and then drill a couple small holes and fill it with expanding foam, then figure a way to reinstall the back panel and seal it all up. Oh well.
Also to add, if you were to do this to block off al the chambers to make it a through and through design, the best bet (and my first thought) was to cut the pipe on the underside of the hat and plug the holes up and then drill a couple small holes and fill it with expanding foam, then figure a way to reinstall the back panel and seal it all up. Oh well.