I installed the backup cam on my truck yesterday, but I don't have the active gridlines. I had to install the entire kit, so all of the wiring had to be done, including splicing the purple wire into the OR/DB wire at the BCM, but I am 99% sure the connection is good (I say 99% because it was my second time ever soldering; my first time was on the PDC wire, which I assume is a good connection because the camera works). I also purchased the AutoEnginuity scanner tool and activated the camera using that. The thing is, I don't have the Parkview options in the Safety settings through the radio, which is another reason I don't think the wiring is the problem, but I may be wrong. I know in Post 10 it says the older software may not show the lines, so I'm hoping this may be the problem, but I can't figure out how to check the software version. When I check for updates on the Uconnect website, it says no updates are available, so the software may be up to date.
Any thoughts?