-
-
Cclint440 reacted to crazykid1994's post in the thread Pwm controller/v6 electric fan install with
Like.
So somewhat good news. Going through troubleshooting and what not for the module and looking through the canbus with the guy doing the... -
Cclint440 reacted to crazykid1994's post in the thread Pwm controller/v6 electric fan install with Like.
Yea. This setup will work for you after I finish. My original attempts were with the 3.6 pentastar fan so I know it can command that fan.
-
Cclint440 replied to the thread Pwm controller/v6 electric fan install.Cool. Thanks for being a pioneer. I remember checking those guys out but never went any further after futile attempts with the dealer...
-
Cclint440 reacted to crazykid1994's post in the thread Pwm controller/v6 electric fan install with Like.
The way this works is using the factory canbus. This module reads the factory canbus signal and uses a few different signals to figure...
-
Cclint440 replied to the thread Pwm controller/v6 electric fan install.Interesting. Does this tap into the factory PWM wire (it's inert on the Hemi trucks) on the main harness or does this bypass everything...
-
Cclint440 reacted to crazykid1994's post in the thread Pwm controller/v6 electric fan install with Like.
Little teaser for everyone. Need a few more bits and pieces to finish the wiring. The last piece came in for the canbus testing finally...
-
Cclint440 reacted to Wild one's post in the thread Caulk04 - Transmission Cooler Upgrade!! This S--T Is Real! with Like.
You have a totally differant transmission behind your Cummins,and i don't think they use a transmission thermostat on your set-up,i...
-
Cclint440 reacted to crazykid1994's post in the thread Pwm controller/v6 electric fan install with Like.
Still working on it. The guy from rpm extreme gave me some halfway instructions on logging canbus for him so I can send him the data so...
-
Cclint440 replied to the thread V6 Efan swap.Free's up engine space. Improves initial throttle response due to less drag. Yeah you need a tune for it to activate it so it kicks on...
-
-
Loading…
-
Loading…
Latest posts
-
Do you have to remove tail pipes when replacing muffler?- Latest: Dodge 1500 4X4
-
-
-
Members online
- Dodge 1500 4X4
- RUUL
- TRAXX
- OC455
- A_mod_too_far
- Joopman
- bfill_rebel
- reyescastillo1
- huntergreen
- Mopar1987
- RidgeReaper208
- Pjc87
- Giorgio_Rampa
- Urbanscout27
- btdt1st
- 1tonOfun
- 21SilverRam
- mildrider
- Atcer2018
- b-rad95
- AndrewR2442
- APPsBeast
- Average J0e
- Wild one
- aliselajl
- Bullwinklle
- Marshalljud
- RamRod37
- ksimmons72
- dandydog250
- ArturoL3333
- healthyrx
- Becker11
- neboysa
- NOV87
- ntc0167
- jws123
- HuskerRam
- Tuggle
- willsz71
- whoop0510
- Kirt Fossum
- Dinky
- Silverio
- REDinAZ
- ric221
- Docwagon1776
- Stags
- trainthemane7
- Thendrix