Recent content by Kpearson

  1. K

    Power steering cooler location

    Good morning, I am looking to see if anyone can answer the question of where the power steering cooler is located on the 1996 ram 2500. Is it in to rad? is it in the same spot as it is on the 1500? I'm going to be heading out to buy new steering components soon. And if it's in the rad, I will...
  2. K

    Fuel injector retaining wire and transmission question

    I have access to a hydraulic press, but I'll most likely leave that section for the pros. I'll have a look around again for the service manual, I had it for a while but then got a new laptop. I live in Red Deer Alberta Canada. So a quick drive would be a little long in the tooth lol.
  3. K

    Fuel injector retaining wire and transmission question

    I don't think the transmission was overly well cared for in the past. I'd like to do the work, but my lack of skill may end up costing me more than what I am willing to have go wrong. A lot of the shops where I live begrudgingly will work on vehicles with parts supplied. And none will allow for...
  4. K

    Fuel injector retaining wire and transmission question

    I'm not really sure, as at the moment it depends on the cost. I know that I will be doing some towing through the mountains, as well as trying to improve on my 4wheel skills. I wouldn't mind having it up to where it would be able to handle a 20% increase in HP and torque. And not turn into a...
  5. K

    Fuel injector retaining wire and transmission question

    Would you happen to have the link to the part in Amazon? For the rebuild kit would anyone have a suggestion as to what kit and stall converter?
  6. K

    Fuel injector retaining wire and transmission question

    Hello, I had taken my truck into the dealership to have them find an issue that I couldn't figure out. While they were working on it, they had noticed the wire clip was missing on all the injectors. Would someone happen to have a photo/part number or knowledge of where to get replacements? Or...
  7. K

    Aaaand again....

    Ok, so here's the scoop. I have a 1996 2500 with the 360 v8. With replacing the TPS, Oil sender, Crank sensor, plugs, wires. And now it won't stay running unless I am holding down the gas pedal to keep the rpms up. Could there be an issue with the computer? I can hear the fuel pump, and when...
  8. K

    Running issues

    Good afternoon, A while ago I posted about not being able to keep the truck running unless I had my foot on the gas. Still have that problem, posted my findings but no other replies to help me with this issue. I hooked up a fuel pressure tester and I have 40 PSI KOEO, when I start it and have...
  9. K

    Running issues

    Good afternoon, Late last year I had posted about not being able to keep the engine in my truck running unless I had the gas pedal to the floor. I can't get logged in on my computer to update the post. Over the last weekend I had the chance to try a few of the suggestions in that post. But no...
  10. K

    Engine confusion

    The engine still has the same injectors that came with it. They were just installed with new o rings. The engine ran fine from the video that I was shown prior to purchase. It's unknown to me on if they were changed out for bigger or not though. I'll get a pressure tester tomorrow and have a go...
  11. K

    Engine confusion

    Good afternoon folks, After using the search, mr google and the service book. I still can't figure out what's going on with the truck. I have a 1996 dodge ram 2500 with the 360 gas engine. After having the compression test done, and it reading 80 on all but 2 cylinders. I had changed the...
  12. K

    Measurements please!!

    Would anyone happen to know off hand what length of Nerf bars a guy would need? I have been looking around for a set, but all I can see are one with double foot pads on them. My Dodge is a 96 2 door. And right now I don't have access to the truck to measure what I'd need. Thanks Sent from my...
  13. K

    Manual seats

    This is the latch that I was referring to. Sent from my E6653 using Tapatalk
  14. K

    Manual seats

    Good afternoon community!! I have a few questions as far as the manual seats are concerned. I have a 1996 ram 2500, and it doesn't have the spare door. My seats manually slide forward amd the back of the seat folds forward. The questions I have are, is it possible to repair the latch for the...
  15. K

    Coolant boiling out

    I've had it where the thermostat failed half closed, as well as my water pump starting to fail. That may be something to check out. Sent from my E6653 using Tapatalk
See more

Latest posts

Members online

... and 1 more.
Total: 1,285 (members: 51, guests: 1,234)
Robots: 1,857

Forum statistics

Threads
195,635
Posts
2,872,780
Members
156,464
Latest member
RayMorrow44

Share this page

Top