24v
-
D
Boost Sensor Question
If I just pulled the boost sensor on my 24 valve and let it hang would the truck roll coal? If I put a pipe plug in its place to keep dirt out would that keep it from over fueling and negate any black smoke? Any negative effects other than being limited to about 2/3 power for example excessive...- doublerun
- Thread
- 24v boost sensor roll coal
- Replies: 0
- Forum: Engine & Performance
-
2
Np241DHD stranser case seal and gasket set compatible with NP241DLD transfer case?
I am going to be reasealing my 1999 dodge ram 2500 24v's np241dld transfer case. I purchased a np241dhd seal and gasket set by accident and I am wondering if it will be compatible? I'm assuming not but just thought I would ask. Couldn't find much in the way of np241dld Seal and gasket sets...- 24vdodgeguy
- Thread
- 24v dodge 2500 np241dhd transfercase
- Replies: 0
- Forum: General Discussion
-
1998.5 24v no power to gauges or fuel pump.
So earlier this winter I didn’t plug my truck in went out to start -40° ended up bending push rods so I pulled the motor. Just put the motor back into the truck this week, everything hooked back up correctly. I go to start the truck and now I have no gauges, tack, fuel light etc… and no power to...- 24vMann
- Thread
- 24v cummins ecm fuel pump pcm vp44
- Replies: 2
- Forum: Heavy Duty
-
T
Need some help 5.9 Cummins Oil leak
I've got an oil leak coming from below/Behind this part. The breather drain tube connects to this. it is above the computer on the driver's side. Does anyone have the parts diagram from here or know what needs to be done? I've got an oil leak (Probably) coming from under this- tkrabec
- Thread
- 24v cummings oil leak
- Replies: 1
- Forum: General Discussions
-
Rebuild kits
Well it's time to rebuild my beast. It's a 2006 3500 5.9 CR with a G56 hung to it. I've got the billowing white smoke and my oil filler cap blows to the moon. I haven't pulled the motor to start building yet but I want to build it strong and never have to worry about it again. Do any of y'all...- Colby Hardin
- Thread
- 24v common rail rebuild
- Replies: 1
- Forum: 5.9 Common Rail
