9.25
-
Rear diff at 200 degrees
Hey guys I recently rebuilt my front and rear diff. I started hearing some gear hum during my high speed break in runs (around 65 it starts to humm). I installed 4.10 gears and heard that a little noise is OK… not sure if that’s true or not. With that I am past the short runs and are onto the...- ArDavid318
- Thread
- 4.10 gears 9.25 diff rear end differential hot
- Replies: 0
- Forum: General Discussion
-
D
Chrysler 9.25 differential grease mesh pattern
I got a new ring and pinion for Chrysler 9.25, I know how to set backlash by adjusting the two threaded inserts on the sides and setting backlash to .006-.010” of play, the other measurement is pinion depth which is determined by shims, I keep playing with the system and setting it up and...- Davido1001
- Thread
- 3.92 9.25 differential differential gears differential rebuild mesh pattern
- Replies: 7
- Forum: Engine & Performance
-
J
Something fishy about this rearend.
I destroyed the Dana 60 case on my 04 1500 4x4 and all i could afford was a used 9.25. I didnt notice that it was a 9.25 at first or I probably would have passed. My original plan was: Swap my carrier since it is a 3.92 LS and the donor case has 3.55 open diff. Now I have 2 questions: 1. Will a...- JAMES J CROSS
- Thread
- 4x4 9.25 bearing race dana 60 differential pinion rear axle rearend
- Replies: 7
- Forum: General Discussions
