ABS Switch

[bendirkss]

So I ran two wires into my truck, both connected to the abs fuse terminals, and wired them into a switch with the fuse in the circuit. I start my truck with the circuit closed, then I open the circuit and the abs light comes on like it should, but it doesn't go back off, and the abs doesn't start working again unless I restart my truck. Does this make sense? And is there anything to change this?

 

[HLram]

sounds about right. You will just have to restart your truck after doing this. Probably no way around it. So, does it really make a difference in the acceleration?

 

[bendirkss]

Makes a very noticeable difference

Sent from my XT1058 using Tapatalk