AMP WIRE ROUTING???

[88ROOK]

So where is everyone running their amp wires, under the sill, under the seat carpet. Whats the easiest route. I know in my old truck they ran all the wires under the sill and behind the seat cause the amp was under the drivers seat

 

[17CrewCab1500]

Along the fender under the hood wire loomed to the rubber boot near the steering wheel column.

Then under the carpet, behind the kick panel and down the drivers side to the amp (under the driver seat or the back wall, where I had mounted mine)

Don't run the power wire in the same channel where the RCAs are.

 

[adurm]

Drill a hole in the clutch delete plate on the firewall. Then run down divers sill plate all the way to the back wall. And yes, try to keep rcas and speaker wires away from the power wire. But I've never experienced interference with them near each other. They're bound to meet near the amp anyways.

 

[88ROOK]

are you guys taking the seat or seats out to make it easier

 

[WilliamS]

No need to pull the seats you can pull the kick panels and shove the wires in there. As for where to come through the firewall use the clutch delete plate. Its plastic and more than big enough for any gauge wire with no risk of chaffing if you do it wrong and dont use a grommet.

 

[adurm]

I want to say the clutch delete is held on by two 16 mm nuts under the dash.