BackFlip Installation and Review

[Saoidh]

Hi I wanted to reply to a thread about soft tonneau covers choices but I had a log-in problem. Reset my password. Couldn't find the thread. So...here are some photos of my BackFlip BK5 installation and review. I would like to say that I chose this cover because it would allow me to load my motorcycle in the bed without having to remove the cover. It only has a small, probably 4 inch, panel that must remain in position after folding it up against the rear window. It gets held in place against the wind by two rods that are secured in place with a twisty-thing, thumb screw? Knob... Anyway, my motorcycle front tire touches it but does no put pressure against it because the front of the tire is against the front wall of the bed. There is a piece of foam tubing lined with tape that you install to keep it away from touching the window. The bed is secure because the tail gate locks and the cover latches cannot be accessed because they are located underneat. I really like this cover and think I made the right choice. I chose one of the lighter models. Pretty sure it's the BK5.

 

[LugsLeadOut84]

Nice. I had Bakflip hard tri-folds on my prior 2 Rams (G2 and MX4) and they worked great and held-up well. This time I tried Bakflip's hard roll-up cover X4s just to take a break from the tri-folds while having the same security. I like it so far. There are a a lot of satisfied Bakflip owners.

 

[14 Lonestar]

I just installed an MX4 on m 22 Laramie, these covers are fantastic. Install was a breeze and I like the fact that it can be opened all of the way and attached to the prop rods.

 

[73revordnal]

2022 Ram 1500 Classic Tradesman Crew Cab V8 5.7 Bed 5 Lug wheels round fuel cover. (w/o Rambox or multifunction tailgate) Ordered a BakFlip MX4 from Nick at Got Exhaust LLC Freedom Motorsports on April 27, 2022 and it arrived safely to my doorstep via Fedex May 2, 2022 Sunday in 4 days from the factory with a manufacture date 3/15/22. AAAAAAAAA++++++++ easy install with 1 wrench and 1 beer. Functions the way I want. Made in USA Thank you to NICK from Got Exhaust. A real person.