Gas gauge not working

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

justin32691

Junior Member
Joined
Dec 21, 2017
Posts
19
Reaction score
1
Location
massachussets
Ram Year
2004
Engine
4.7
Just had a gas leak and had my fuel pumped changed they also changed the fuel line now after i put gas in the gas needle does not move can anyone help
 

xtremewlr

Senior Member
Joined
Feb 12, 2015
Posts
809
Reaction score
355
Location
Tucson, AZ
Ram Year
2004
Engine
Hemi
If it was working before you had it repaired and isn't now, you should probably take it back to whoever did the work and have them fix the problem.
 
OP
OP
J

justin32691

Junior Member
Joined
Dec 21, 2017
Posts
19
Reaction score
1
Location
massachussets
Ram Year
2004
Engine
4.7
Yea i called him he said the ball could be stuck and to fill the tank so i did that and still nothing
 

SYKRAMMAN

Banned
Joined
Jul 10, 2017
Posts
2,401
Reaction score
1,642
Location
Jersey shore
Ram Year
06 Mega
Engine
5.7
Ask to see recipe for pump, make sure they didn’t put in a garbage one. A lot of shops do that. In any case I would bring it back. Don’t try to mess with it cause they might try and say you did it.
 

CostaRam

Senior Member
Joined
Dec 26, 2016
Posts
349
Reaction score
95
Location
Costa Rica
Ram Year
2011
Engine
5.7 HEMI
Just had this with my Dakota,
fuel pump has fuel gauge sender intergrated.
Thei either broke something or used the wrong pump assembly
Bring it back!
Chris
 

Jbaker33

Member
Joined
Nov 30, 2017
Posts
85
Reaction score
36
Location
Cadillac, MI
Ram Year
2006
Engine
5.7l hemi
I had the same issue. Mine was the connector beneath the drivers side door, behind plastic wheel well. Was told that it needed to be connected to depressurize the fuel system(took injectors off to clean/inspect them). I ended up messing up the clip than close it completely and wasn't connecting right. Before I found the problem my left passenger turn signal went out, not a bulb issue. Once I zip tied the connector back together everything started working and has been since
 
Back
Top