headlight adjustment

[jojo750]

since i lowered my truck, apparently my headlights are blinding people in the oncoming traffic. so i was wondering if there is an adjustment to lower the aim of the headlights?
2011 ram
i looked around the assembly and didnt see anything, but then again, it mightve been staring me in the face.

any help would be appreciated.
thanks
joey

 

[HKkid]

Wait what? You lowered your truck and now you're blinding people? I don't see how that is possible. There are adjusment screws on the lights though.

 

[BlackedOutHemi]

http://www.ramforum.com/f75/how-aim-your-headlights-4th-gen-rams-9156/

 

[jojo750]

same thing happened when i lowered my ssr.
seems since the rear was lowered more than the front, the headlights will actually point slightly higher. hard to explain.
if i aim at my garage door, my low beams are almost the same height as my high beams.
i just want to see if i can aim them a little lower.

 

[jojo750]

http://www.ramforum.com/f75/how-aim-your-headlights-4th-gen-rams-9156/

thank you sir.
it was staring me in the face.

 

[BlackedOutHemi]

I wouldn't say that! I would never look in the holes on the fender. Lol.

 

[HKkid]

Ahh...gotcha.

 

[0212353]

yeah, crazy location for the aim!

 

[OutlawTrucker]

Yea but they put the arrow there for dummies. ADJUST HERE LOL.

 

[quietpeen]

lol..id does go against thinking. but it makes sense since you did level it with the lower so how they were aimed is different now

 

[Jmhm17]

Yeah im going to bring this back from the dead.. I noticed there are 2 holes each one has an arrow.. I dont want to start cranking on one and not realize its the horizontal screw 20 turns later waiting to see a vertical change. anyone have an update on the newer Rams? I have a 2014 specifically

 

[0212353]

depends on your truck on the 13+

If you have the quad lights, use the hole that is furthest from the grill. The OEM projectors would use the hole closer to the grill

 

[Jmhm17]

oooooooohhh!!! that makes sense. it was really sunny out today and I noticed there was only a screw in the back one (I have quads), I figured the glare and how deep the hole was i needed to get a light in there to see the other screw, but according to you there isn't one. Perfect, thanks for clearing that up!! I feel dumb now haha

 

[Pull Ya]

I found out that on the 13's you have to go clockwise to lower the beam instead of counter clockwise.
jay

 

[Andrew King]

Is the adjustment for the whole housing or can you adjust the high beams separate? This is on the housings with a separate high beam bulb.

 

[GTyankee]

This EARLY Gen 4 Ram headlight is face down, the adjuster is pointing straight up in your Ram






2009 Dodge Ram