Itsme71190
Senior Member
Hey trap. Do you remember the size of cord and flange size?
Rebadge Design
- Thread starter Trapinator
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
EagleChief
Senior Member
- Joined
- Jan 6, 2015
- Posts
- 1,943
- Reaction score
- 968
- Location
- Oklahoma
- Ram Year
- 2014 Big Horn
- Engine
- 5.7 Hemi
Just to compare, when he replies to you, the cord I bought was 3/16". I don't remember the flange size, though.
Had to edit the cord size...
Sent from my iPhone using Tapatalk
Had to edit the cord size...
Sent from my iPhone using Tapatalk
Last edited:
EagleChief
Senior Member
- Joined
- Jan 6, 2015
- Posts
- 1,943
- Reaction score
- 968
- Location
- Oklahoma
- Ram Year
- 2014 Big Horn
- Engine
- 5.7 Hemi
It possibly could. Depends on where your vibration is coming from, and where you use the cord, or IF, you can use the cord where the vibration is.
EJR_3
Senior Member
- Joined
- Jun 6, 2016
- Posts
- 223
- Reaction score
- 90
- Location
- North Las Vegas
- Ram Year
- 2018
- Engine
- 6.7L Cummins
Few interior shots. All four doors one piece. Few pieces around dash. Basically just test fitted it and where the fitment was good was where it went. Some of the cracks are just too big for the seat cord to fit snug.
-Trav
Sent from my SM-G930V using Tapatalk
Everything for the most part is easy, but how did you mange to do the center console around the radio? I can't get it to look as clean as the pictures? Having issues towards the top.
Last edited:
OP
OP
Trapinator
Senior Member
If I can remember correctly that was a tough spot. Did u try like flipping the cord where like the flange is the other direction I did that in a few spots and I think it snugged it up better instead of it wanting to pop out.
Sent from my SM-G930V using Tapatalk
Similar threads
