TMH1
Junior Member
I have a 2008 Dodge Ram !500 5.7L engine.(3Rd Gen) Can anyone tell me how the re-learn is supposed to go and how to do it on my truck... I have just replaced the throttle body... Thank You
throttle body re-learn
- Thread starter TMH1
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I have a 2008 Dodge Ram !500 5.7L engine.(3Rd Gen) Can anyone tell me how the re-learn is supposed to go and how to do it on my truck... I have just replaced the throttle body... Thank You
srv1
Senior Member
- Joined
- Nov 7, 2019
- Posts
- 340
- Reaction score
- 248
- Location
- blasdell n.y
- Ram Year
- 2004
- Engine
- 345 c.i. HEMI MAGNUM
haynes manual says to 1.disconnect neg. batt. cable for about 90 sec. 2.reconnect cable 3.turn ign. switch to on but dont start 4.leave the ign. switch in the ON position for at least 10 sec.
(7) The 5.7L V-8 engine is equipped with a fully electronic accelerator pedal position sensor. If equipped with a 5.7L, also perform the following 3 steps:
(a) Connect negative battery cable to battery.
(b) Turn ignition switch ON, but do not crank engine.
(c) Leave ignition switch ON for a minimum of 10 seconds. This will allow PCM to learn electrical parameters.
(d) The DRB IIIt Scan Tool may also be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
(a) Connect negative battery cable to battery.
(b) Turn ignition switch ON, but do not crank engine.
(c) Leave ignition switch ON for a minimum of 10 seconds. This will allow PCM to learn electrical parameters.
(d) The DRB IIIt Scan Tool may also be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
