Trans Line

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

LS5DodgeRam

Senior Member
Joined
Feb 17, 2013
Posts
793
Reaction score
115
Location
South Florida
Ram Year
2004
Engine
4.7L v8
Hey guys, I bought a dodge factory match trans temp gauge from autometer. I am trying to tap into the trans line, rather than drill a hole in my trans case. Does anybody know which of the two is the transmission hot return line is?

I have the 4.7L 5 speed automatic

thanks!
 

KGBIGCOUNTRY

Senior Member
Joined
Jun 29, 2010
Posts
13,309
Reaction score
475
Location
MECH, VA
Ram Year
2004 RCSB/2005 QCSB
Engine
5.7 / 5.7
Get an adaptor and put it off of one of the trans test ports on the side.
 

OlDirtyJohn

Senior Member
Joined
Jun 26, 2010
Posts
1,518
Reaction score
50
Location
Naha-shi, Okinawa, Japan
Ram Year
2004 Quad Cab 2500 *Sold*
Engine
Hemi 5.7
just like Kenneth said. No need to drill. use test port 3 on the right side of the trans.
 

redram2007

Senior Member
Joined
Sep 29, 2012
Posts
1,092
Reaction score
60
Location
Colorado Springs (Ft Carson)
Ram Year
2007
Engine
4.7
Last edited:
OP
OP
LS5DodgeRam

LS5DodgeRam

Senior Member
Joined
Feb 17, 2013
Posts
793
Reaction score
115
Location
South Florida
Ram Year
2004
Engine
4.7L v8
I was going to do the trans line so I didn't have to drill into the case, what and where is test port 3? Is it one the case? How would I go about installing this there?
 

redram2007

Senior Member
Joined
Sep 29, 2012
Posts
1,092
Reaction score
60
Location
Colorado Springs (Ft Carson)
Ram Year
2007
Engine
4.7
I have the factory matched trans temp gauge as well. But the sender and adapter that comes with it won't fit into the test port 3 ( located on the passenger side transmission). Therefore you have to buy the 1/8 sending unit and the 1/8 to 1/16 adapter. Once you have those you simply unscrew a plug on the transmission install the adapter and sending unit (part numbers above) and wire it up. If you need I can take a picture of mine installed.
 
OP
OP
LS5DodgeRam

LS5DodgeRam

Senior Member
Joined
Feb 17, 2013
Posts
793
Reaction score
115
Location
South Florida
Ram Year
2004
Engine
4.7L v8
Sweet, thanks for the help guys! I will get it up and running as soon as possible!

By the way do you know if autometer can replace the bezels on their gauges if I send it in? I'm very aggravated since when I mocked it up I scratched the bezel :mad: I do not like them even though they are minimal
 
Top