Truck won’t start when engine is hot only when is cooled down 4.7

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

jeovanicorro

Member
Joined
Sep 26, 2023
Posts
35
Reaction score
6
Location
Dallas Texas
Ram Year
2007
Engine
Hemi 5.7
02 4.7 ram engine just got rebuilt and truck turns on and runs fine until i turn it off after its been at operating temperature if i let it sit for like 5 minutes and try cranking it it only spins i haven to let it cooldown and it starts back up without any problem i swapped out the fuel pump today and also got new injectors aftermarket not oem.
 
OP
OP
J

jeovanicorro

Member
Joined
Sep 26, 2023
Posts
35
Reaction score
6
Location
Dallas Texas
Ram Year
2007
Engine
Hemi 5.7
i have the battery under warranty! so i’m heading tomorrow to my local autozone and getting it replaced it’s an AGM 65 that’s the size of the third gen rams
 
OP
OP
J

jeovanicorro

Member
Joined
Sep 26, 2023
Posts
35
Reaction score
6
Location
Dallas Texas
Ram Year
2007
Engine
Hemi 5.7
swapped the battery out and still doing the same thing also replaced my terminals i’m thinking the injectors i have are bad there not oem because the truck would start fine if i pour gas into the tb it starts back up and drives normal
 

3pedals

Senior Member
Joined
May 28, 2020
Posts
192
Reaction score
97
Location
Central Valley
Ram Year
2008
Engine
4.7
Had similar issue on my ‘08…ended up being wires under driver side of firewall that supply power to fuel pump There was a connector with loose wires that would cause the same issue…always fired up cold, but it shut down warm wouldn’t start until after sitting for a while. Other thing to check is fuel pump relay…not sure if separate or integrated into TIPM on your 2002.
 
OP
OP
J

jeovanicorro

Member
Joined
Sep 26, 2023
Posts
35
Reaction score
6
Location
Dallas Texas
Ram Year
2007
Engine
Hemi 5.7
it was my injectors the chinese aftermarket ones bad quality i put my oem ones back on and worked fine
 

Latest posts

Members online

Forum statistics

Threads
211,613
Posts
3,069,043
Members
172,352
Latest member
Clusterfark
Back
Top