WTB: 1500 rear axle w/3.92 gears

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Status
Not open for further replies.

Gordinho80

Senior Member
Joined
Jan 16, 2018
Posts
641
Reaction score
371
Location
Monroe, NJ
Ram Year
2012 1500 Big Horn
Engine
Hemi 5.7
My buddy has a 2011 1500 with 3.92 gears. His pinion nut is loose and apparently has been for a while. Dealer suggested he rebuild the diff or replace the axle. I think it might just need a tightening but I have not seen it in person. He's going out of town for a couple of weeks and when he gets back, we're going to unbolt the flange at the rear diff/driveshaft and inspect. If the pinion nut just needs a little tweaking, he should be ok, but if its backed out a lot, I'm going to suggest he find a replacement axle. So I'm looking here to see if anyone has one so we could line that up.
 

Karlsweg

Senior Member
Joined
Nov 10, 2017
Posts
1,025
Reaction score
949
Location
SW Florida
Ram Year
2007
Engine
5.7 hemi
Chances are pinion bearings are toast and gear oil will be full of metal!
 

crash68

ACME product engineer
Staff member
Administrator
Supporting Member
Joined
Mar 20, 2016
Posts
10,767
Reaction score
16,873
Ram Year
2015
Engine
3.0 EcoDiesel

scott lass 18

Senior Member
Joined
Nov 4, 2018
Posts
458
Reaction score
170
Location
rocklin ca
Ram Year
2010 ram 1500
Engine
5,7
mine cuz I change gearing games going on it was a new dodge ring and pinon too ! soooo sucks dodge so can anyone tell could they have turn and striped it dealler ! 45,000 on new one I had done hope didn't wreck my truetrack in it ! why they didn't fix my problem first the do dang recall !
 

circuitguy

Senior Member
Joined
Aug 10, 2018
Posts
1,930
Reaction score
1,556
Location
Elk Grove, CA
Ram Year
2017 Ram Tradesman Regular Cab
Engine
5.7L HEMI
I know where there is a 2017 Ram Sport rear axle with 3.92 limited slip. Truck has under 10k miles on it. There asking $800 for it.
 

Pull Ya

U.S. MARINE VETERAN
Supporting Member
Military
Joined
Jan 16, 2012
Posts
15,788
Reaction score
23,062
Location
Cedar Creek, Tx
Ram Year
2015
Engine
5.7 Hemi
You can buy a ring and pinion and an install kit from Moe's Performance, a preferred vendor on this forum.
Jay
 

Eddie S

Banned
Joined
Sep 7, 2018
Posts
0
Reaction score
12
Ram Year
2008
Engine
v6
mine cuz I change gearing games going on it was a new dodge ring and pinon too ! soooo sucks dodge so can anyone tell could they have turn and striped it dealler ! 45,000 on new one I had done hope didn't wreck my truetrack in it ! why they didn't fix my problem first the do dang recall !


I'm sorry but.......WHAAAAAAAAAT??????????
 

scott lass 18

Senior Member
Joined
Nov 4, 2018
Posts
458
Reaction score
170
Location
rocklin ca
Ram Year
2010 ram 1500
Engine
5,7
mine cuz I change gearing games going on it was a new dodge ring and pinon too ! soooo sucks dodge so can anyone tell could they have turn and striped it dealler ! 45,000 on new one I had done hope didn't wreck my truetrack in it ! why they didn't fix my problem first the do dang recall !
was so luck and no gear were fine dodge the nut was strip when testing change fluid and a deron nut sooo better all set now was a 200.00 cost oh well they did a lot of engine work fuel injector exhaust manifold trains relay ? think other exhausted now ticking oh well ! sure hope in a few months can drive to the red wood sucks dec to know 500 miles !
 
Status
Not open for further replies.
Top