Here is final list of parts that I used. Original list was not right. I returned a few parts and end cap was wrong.
5VC941Z6AA bezel center console
5VC95DX9AC base floor console
1NN14DX9AB console base
68053384AA rear duct (will not tie into factory. Have to cut and tie into your existing one)
1HS07DX9AA access cover
1HR97DX9AC extension panel
1HR96DX9AC extension panel
55365120AA bracket front
55365121AD bracket 2
1QV13DX9AA console base mat
5NB13LA8AC armrest diesel grey OR order 5NB13DX9AC for black armrest
1RB84DX9AA air outlet
1RB86DX9AA air outlet
68096423ac wire harness
1VY921 X9AD bezel instrument panel with grey sides and black center
68214340AA retaining panel
5NA01DX9AA rear cover
6-100 1" bolts x 4 (ace hardware or Home Depot etc ) with washers (secure console to bracket )
2 -5/8 by 1" bolts, nuts and washer (secure front bracket )
2 bolts (don't know size ) for rear bracket.
There may be harness to tie usb,aux etc to plugs from console to factory plugs?? I spliced the wire harness from old jump seat. One end is plug and play to wires under seat other end gets spliced to new console ). I also extended one usb from old bezel about 12" to new console bezel. Both are easy you just match colors and tape.
Currently doing this swap in my 2011. I have most of it done except the duct work, the console I got was from a 2014.
I had vents in my jump seat and removed what looks like item 8 in the 2014 BOM in order for the ducts in my console to be close, but now I just need a short piece (~6" Long) for the console to hook back up to the duct piece under the dash.
I know you said that 68053384AA was not the right duct, which is the one that shows up in the 2011 BOM (item 5), but I was looking at the BOM for a 2014 and it looks like 55056931AB (item 7) might be what I need. Has anyone actually got the right duct piece for this? I tried to search through this thread and couldn't find anyone who actually found the right piece.
Thanks!
Edit: NVM looks like that is the piece I'm looking for, guess I missed a page.
CONSOLE BASE FRONT BRACKET - MOPAR (55365120AB)
CONSOLE BASE REAR BRACKET - MOPAR (55365121AD)
REAR DUCT - MOPAR (55056931AB) <- Installs onto front bracket to adapt on a crew cab.
The screws for the sides of the console are M6 bolts.
I pulled the nut plates out of the two that held the drawer in. They pop out to the front, I used a pick tool to pull them and then snap back into the console holes.
Also a couple of nut plates for the front bracket with screws or you can do what I ended up doing and use a couple bolts and nuts like the OP did and I did. Trying to find the M8 Nut plate that snaps in so I can install the two M8 bolts that came out.