hangac1093
Member
- Joined
- Oct 17, 2014
- Posts
- 84
- Reaction score
- 83
- Ram Year
- 2015
- Engine
- Hemi 5.7
After months of research I got it done. Like most I was back and forth on 4" or 6" lift. I knew I didn't want anything lager than 35" tires. I wanted it to look lifted but not too much wheel well to make the tires look small.
So I went with the SuperLift 4" kit w/Bilstein's. I bought a TGC 1" rear coil spacer so I could get the rear up a bit more and adjust the Bilstien's up front to level. The wheels are Fuel Octane's 20x9" 1mm offset and the tires are Nitto Trail Grapplers 35x12.5.
My goal was to try and get a stance between the 4" and 6" lifts. Not sure if I did or if it is closer to a 6" lift now, but I love the way it looks. I did all the work myself in a weekend. I installed the the rear spacer off the get go and set the Bilstein's to the second ring(.7") and the truck ended up with 2" of rake. So I set the Bilstein's to forth ring(2.1") and and it still had over an inch of rake.
(Edit) I ended up taking the rear spacer out and now have about 1/4" of rake. Current fender measurements below.
Fender Measurements
Front Driver - 43 1/2"
Front Pass - 43 1/2"
Rear Driver - 43 3/4"
Rear Pass - 43 3/4"
Other Mods
Factory 2500 flares
Factory Black Ram Badges
Had Crome bars on the grill painted by my local body shop. (Luckily the guy who owns the shop is a good friend, because it only cost me paint and he said it was a pain in the ass to prep all of them)
Mufflex 18"
Moe's 5" Tips
The day I brought her home.
Now
So I went with the SuperLift 4" kit w/Bilstein's. I bought a TGC 1" rear coil spacer so I could get the rear up a bit more and adjust the Bilstien's up front to level. The wheels are Fuel Octane's 20x9" 1mm offset and the tires are Nitto Trail Grapplers 35x12.5.
My goal was to try and get a stance between the 4" and 6" lifts. Not sure if I did or if it is closer to a 6" lift now, but I love the way it looks. I did all the work myself in a weekend. I installed the the rear spacer off the get go and set the Bilstein's to the second ring(.7") and the truck ended up with 2" of rake. So I set the Bilstein's to forth ring(2.1") and and it still had over an inch of rake.
(Edit) I ended up taking the rear spacer out and now have about 1/4" of rake. Current fender measurements below.
Fender Measurements
Front Driver - 43 1/2"
Front Pass - 43 1/2"
Rear Driver - 43 3/4"
Rear Pass - 43 3/4"
Other Mods
Factory 2500 flares
Factory Black Ram Badges
Had Crome bars on the grill painted by my local body shop. (Luckily the guy who owns the shop is a good friend, because it only cost me paint and he said it was a pain in the ass to prep all of them)
Mufflex 18"
Moe's 5" Tips
The day I brought her home.
Now