Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I have the recon led dome light that is a bluish tint. Will the mopar kit have a similar color to the light or no?
Awesome job. Turned out great.I decided to try the footwell light install and had hoped to find a deal on the Grand Cherokee Light sockets but opted for a much cooler idea in my opinion. LOL
I went to a junkyard and was hoping to find the clips to plug right into the Ram 2500 harness for the footwell lights but had no luck finding a new enough vehicle either. I ended up yanking the trunk light sockets from a couple of Dodge Neons and then just soldered the ends of each wire so they were hard and plugged them directly into the harness and some shrinkwrap to keep things clean.
I pushed the drivers side light through the larger square hole and zip tied the part sticking out and then slid on a rubber washer to clean up the look. For the passengers side I followed your instructions to take off the cover and found the harness just inside the top edge of the foot panel and did not even have to take that panel off. I then put a small hole in the round indent where the Jeep light socket would have gone and then put a small rubber washer over the Dodge Neon light socket, pushed it through the hole and then added another rubber washer to lock iit in place. I then stuck the wire directly into the light harness plug and tested out the lights before reinstalling cover. I then took out the regular bulbs I was testing with and installed some cool looking 30 lumen blue T-10 LED bulbs I bought from Amazon
Amazon.com: VLEDS 2pcs Blue 194 T10 2825 360° Long Life 1 LED Bulb: Automotive
They look super cool and are not overpowering. For a brighter look I was going to use the 100 lumen Amazon.com: SiriusLED Super Bright 1 W LED Bulbs with 360 Degree Projection for Car Interior Lights Gauge Instrument Panel Dome Map Side Marker Door Courtesy License Plate T10 168 192 194 2825 W5W Blue: Automotive but I decided to try the V-led Bulbs first and I think I am happy with them. View attachment 145865 View attachment 145866 View attachment 145867 View attachment 145868 View attachment 145869
Yes you can just tap into the oem wire harness and run LED strips, very simple to do. I'm running my red footwell lights, as well as my door sill lights off them. No issues
View attachment 82075
one question- are these always on, or only when doors are open?
ok. My sport already has footwell lights.