Finished up posting what I had done in the 2017 RAM, replaced the Alpine amplifier, replaced the stock speakers, and sub.
I have tested with multiple amplifiers and speakers and the goal is to provide and upgraded system for as cheap as possible while making the installation as easy as possible...
So recently or more like a year now my truck been disconnecting the audio i had the base model radio before i upgraded to the 9inch android screen and from there it started to disconnect and when i
put my stock radio back on it still did it but not as often. my truck came with a full set of...
Audiocontrol D4.800 Amp, includes Line out converter, digital signal processor, 30 band graphic EQ, fully adjustable crossover points on all channels including the amp output RCAs, channel summing and time alignments, accepts up to 6 channels of 200w line level inputs or RCA inputs, signal...
Seriously, if you have the base 6 speaker this is the way to go to rock that truck! Full DSP built into amp. Tune all channels and RCA out independently. I loved it so much I got the 6.1200 for my Alpine system replacement.
I put infinity reference 3032cfx in the dash parallel with Kappa 6.5...
Hello, guys!
As i have learned myself by hard way, stock amp routes parksensor sound to speakers.
Now i have installed PX6 "Tesla" head unit based on Android 9.0 and aftermarket amp – parksensors sound is disappeared.
Have anybody already bypassed factory amp in similar situation? Now i am...
I have a 2019 Ram 1500 Classic with the base sound system (non-Alpine). I'm installing a mono amp to power two 12" subs under the rear seats, using a LC7i to get the signal from the rear speakers.
I tapped into the RR+/- & LR +/- wires directly behind the head unit for speaker-level inputs...
Need some help...
Today, I got in my truck to make a run uptown and to my surprise, the sound coming out of my speakers was really bad! I got out of the truck to check the speakers and found that both 6x9 door speakers weren't working. All the rest were working, but sounded terrible. I checked...
I was looking at a JBL 4505 5 channel amp at Crutchfield, and have a question for the experienced here. My standard 6 speaker setup has no output to a sub, so the only inputs to the amp would be the speaker wires. My question is this: given all the ways to set up this amp, if I used the low...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.