connector

  1. R

    Unused connectors in dash

    In my 2006 SLT 4.7 behind the hvac controls in the dash there are 2 unused connectors. They are just inserted in the plastic of the dash to secure them. What can they be used for on higher spec RAMs? In the pic they are the most left and right connectors inserted in the dash.
  2. C

    Found Unplugged Connector in Engine Bay.

    Hello, Thank you in advance for any help. About the truck: 2016 Ram 2500, 6.7L, Laramie I was changing the fuel filter when I noticed a cable that was unplugged. I looked around and could not fined where to plug it in. It is on the driver's side of the engine. Looks like it is part of the same...
  3. S

    Connector (C1 Connector?) under steering column keeps backing out. 2003 Dodge Ram 2500 Quad Cab Cummins.

    First post. One Owner (Me) 2003 Dodge Ram, 4wd, Auto, Quad Cab, SLT, Cummins In my attempts to troubleshoot ignition problems, I have discovered this white connector will not lock and stay. What are my options? My local shop was able to identify this as the C1 clockspring connector, and the tech...
  4. M

    Fuel rail end broke off in quick connect

    3rd gen hemi 5.7 with a stupid problem So I have the worst luck I swear. Had my fuel line removal tool. Went in ok. Barely pulled and the darn thing broke off immediately in the quick connect. Tried putting the tool back in and the broken fuel rail line must be severely rusted to the back of it...
  5. T

    Help w/ Un Pinning FCM Wires from connectors

    Hey Rammers.... lol. I have searched here and other sites + googled ... I cannot figure out what tool i need to unpin the wires from the FCM. Trying to remove wires from a donor truck and install for upgrades to my 14 RCSB. I got lucky with my fog light project and they popped right out when i...
  6. L

    Upgrading front seat from Manual to Electric

    I'm upgrading the front seat like the title says and I went out and bought a 3-piece electric front seat to replace the manual bench that I had already in my 98 Dodge Ram 1500 and didn't realize that my truck wouldn't have an existing connection now I'm not sure how to find what connection to...
  7. S

    Wiper connector diagram

    Hi My wiper motor died after 15 years and 308.000 kilometers, so I bought a replacement. Sadly it has the wrong connector it's 5-pin. Now I could buy this adapter from APDTY: https://apdty.com/products/apd-05127710aa?_pos=1&_sid=1146ffb6b&_ss=r But for just changing the connector I don't pay...
  8. FeelinNauti

    Replacing Microphone in Headliner RAM 2017

    I know how to pop out the microphone from the overhead headliner but how does one get to the connector? I want to check the line and replace the microphone if needed on the drivers side.
  9. David Janes

    Tail Light Change

    Hello, I have a 2013 ram 1500 tradesman. I bought a set of recon tail lights off a guy that took them off his 2013 and he said that the connectors might be different for the brake light, turn signal connector. The connector in my truck is has 3 tails and is more oval and the connector on the...
    • David Janes
    • Thread
    • 2013 ram 1500 connector tail lights
    • Replies: 5
    • Forum: Exterior
  10. JackPang

    Manufactured Backup Camera without wiring.... where to get one?

    Hi Guys, I am new to this forum, hopefully can get some helps. My 2017 Ram 1500 ST has the backup camera installed on the tail gate handler(see pic 1 below), but no wiring inside, I found the connector of this camera is a special six PINs (see pic 2 below). Does anyone knows where I can get...
  11. C

    EGT connector

    Hi all, Was wondering if anyone knew the trick to disconnecting the EGT sensor connector. I need to disconnect the harness for an aftermarket install and cannot see if I am missing a some kind of locking pin, etc.
  12. J

    Rat chewed through wire. Unknown connector (pictured incl.

    Tred to start the engine but it wouldn’t kick on. It’s been a few weeks since I drove it. Found a rat nest and also this wire chewed through. Seems like an easy fix but I do t know the part?

Latest posts

Staff online

Members online

... and 8 more.
Total: 1,441 (members: 58, guests: 1,383)
Robots: 1,985

Forum statistics

Threads
195,648
Posts
2,872,891
Members
156,483
Latest member
Jayhull82

Share this page

Top