1960 International R-190 4X4 build. DT360 / Eaton 6 speed / NP271 / F550 Frame
- Thread starter DILLIGAF
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Wild one
Senior Member
- Joined
- Jan 17, 2016
- Posts
- 23,899
- Reaction score
- 55,065
- Ram Year
- 14 Sport
- Engine
- 5.7
Carney has probably deemed that illegal
OP
OP
This is icing on the cake then. The most redneck way to skin a deerCarney has probably deemed that illegal
OP
OP
Wild one
Senior Member
- Joined
- Jan 17, 2016
- Posts
- 23,899
- Reaction score
- 55,065
- Ram Year
- 14 Sport
- Engine
- 5.7
Ain't no way that suckers falling off
Where are you buying your steel at,as i gotta start buying there too
OP
OP
Grabbing myself a free set of leaf springs
They wanted $1,500 for a set of custom leaf springs for my build. I rather spend a couple hundred bucks on you bushings and make some mounts with the plasma table instead
On board air saved the day again
They wanted $1,500 for a set of custom leaf springs for my build. I rather spend a couple hundred bucks on you bushings and make some mounts with the plasma table instead
On board air saved the day again
Last edited:
Yardbird
Senior Member
Grab that what appears to be a Brockway Cabover and do it next...lol... If that is a Brockway, and not a Mack, there are very few of those left.
I say Brockway because of what appears to be a chrome running dog on the lower front of the drivers door.
I used to own a 1972 Brockway truck like that one.
I say Brockway because of what appears to be a chrome running dog on the lower front of the drivers door.
I used to own a 1972 Brockway truck like that one.
