2018 2500 6.7 forcing ReGen(de-Soot) with AlphaOBD and monitoring with Torque Pro

[WY-Dave]

OK I have been searching many forums, youtubes etc for the last 3 days.
During those searches I have heard "you can do a stationary regen with AlphaOBD, but no one ever says how and where the setting is in AlphaOBD. So anyone here know how?



EDIT: With the help of 18CrewDually, crash68 and Fuel35 67 I have the steps. I am putting them in order to have it one place and moving the TorquePro to a separate thread.
I will be doing it tonight and post what happens



Dipstick me got stuck on Body Computer vs Engine




----------------------------- Partial Regen

 

[Fuel35 67]

I’d check over on Cumminsforum.com.

 

[18CrewDually]

 

[18CrewDually]

You can also do a partial desoot during a performance test.

 

[crash68]

I know the option to force a stationary regen with AlfaOBD is in the Cummins engine controller(as seen above^^). I think the engine coolant needs to be over 140° before you attempt to force a regen.

 

[WY-Dave]

Ok part 2: If you use TorquePro (with the custom PIDs) show me what you got!

 

[WY-Dave]

Well that didn't work, trying the aftertreatment version. This was after a 110 mile trip
It started the procedure, idle went up then about 30-45 sec get the msg. Did it 3X

used the 2018+ PowerNet (do have the sec bypass cable)

 

[WY-Dave]

Well the performer test with the partial stationary desoot did the job. it took exactly 30 min.

 

[Fuel35 67]

Every now and then ya need to work that engine, it’ll help keep your mind sane!! Glad it worked out for ya!

 

[18CrewDually]

Did you do the PM Sensor Regeneration?

 

[WY-Dave]

Did you do the PM Sensor Regeneration?

I tried it 3x and it would idle up, "starting" then give the msg
Failed. Requested procedure is not supported by the unit.