Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
^^now that's a sharp truck right there....very nice
Put some 6112 and 5160 Bilsteins on a friends RAM 1500 2011, holy **** those rear upper inner nuts was hard to reach. And the Left front lover bolt was stuck in the bushing... Got it out in the end but not in one piece...
Lets se if the front settles a bit, otherwise it will get a small lift in the rear
View attachment 128764
Bilstein 6112's in the front and Bilstein 5160 in the rear. Rides like a freaking Cadillac.
It was set at max (2.6") from dealer, the shocks came as they where on the table in the picWhat height setting did you go with in the front??
Maybe 22x12 American force burnouts on some 33x12.5 toyo mts?
Sent from my iPhone using Tapatalk
Close! 22x12 burnouts on 35x12.5 Toto mts [emoji3]
Sent from my iPhone using Tapatalk Pro
This is a nice set up. I have the exact same truck and looking at going this route. All you have is Bils @2.8 on the front and no other lift?
Well it’s actually bils @2.8 and a 2” level. I’m sure I’ll get some heat for that but I’ve been using that setup for 6 months no problems
Sent from my iPhone using Tapatalk Pro
Well it’s actually bils @2.8 and a 2” level. I’m sure I’ll get some heat for that but I’ve been using that setup for 6 months no problems
Sent from my iPhone using Tapatalk Pro