Body lift questions?

[zotes1500]

Yes if its the pa 3" you'll have a steering extension and have to drill the bumper brackets.

I've went over every connection that get's disconnected in the install. They left a lot of grounds off and they tried to replace em with like little 18guage wire. Im hoping that is the issue. Either way I had to drive 1500miles without cruise thanks to them.

Hope your install goes better! post pics after and if you see anything that would cause my problem lmk! haha

god that would **** me off. did u try to get ur money back or anything. im sure that would be a hassel but still

 

[mattman_13]

god that would **** me off. did u try to get ur money back or anything. im sure that would be a hassel but still

They only charged 300 for the install. Which I would have gladly paid more for a quality install without all this headache. But it was supposedly a good 4x4 shop. I'm gonna take it to dodge when I get some time and see what they say and contact the shop and try to make them pay the cost to fix.
You and I have TERRIBLE luck with these trucks.. lol

 

[2nazt]

Doing mine myself in few months so excited!! Stinks you had problems from a shop that sucks.

 

[GlOcKnRaM]

Where did u get the five inch tips from? They came black?

Yeah mbrp tips..got them from Matt @ Moes Performance!

 

[that white kid]

Just put it on today in about 5 hours so far no problems and I don't have to move the exhaust because it looks fine now I'm just debating on if I should keep my steps off or not and I managed to only use one dril bit and it only took about 3 min to drill all 4 holes

 

[0212353]

you must have had a superduper special diamond plasma bit! LOL

lucky!

 

[that white kid]

It was a diamond tipped concrete bit but it works great on metal some guy down the road frow me owns a big concrete business i gotta give it back to him its like a 200$ drill bit lol

 

[mattman_13]

Just put it on today in about 5 hours so far no problems and I don't have to move the exhaust because it looks fine now I'm just debating on if I should keep my steps off or not and I managed to only use one dril bit and it only took about 3 min to drill all 4 holes

If i were you I'd be tooting my horn... Mine didnt even go that smooth and I got a shop to do it!

The install isnt technically done till you get pics on ramforums though.. fyi haha

 

[that white kid]

ok ill try in the morning now i just gotta figure out how to post pics lol

 

[mattman_13]

Make a photobucket and copy and paste the image code. Or if you need to email them to me and ill post em up for you.

 

[that white kid]

Mattman_13 do you have gap guards for the front?

 

[mattman_13]

Yea and they are over priced pieces of rubber. Installing them with a drill was ridiculous so I just used a pick. Just one of the sharp straight picks and a philips head screw driver. Id hold the gap guard up and use the pick to push through the plastic then the philips head Id ram through (pun intended) and it'd open it up enough for the push pin to go through and stay.