muzupan
Senior Member
- Joined
- Nov 23, 2015
- Posts
- 234
- Reaction score
- 105
- Location
- Rocky Mount NC
- Ram Year
- 2019 Ram1500 Crew Cab
- Engine
- Hemi 5.7
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
its very simple.
once installed, looking at the pcm from the front of the truck.
the left side top bolt is suspended in the air and is nut and bolted to the Pulsar.
the bottom left bolt on the PCM will bolt into the top bolts factory original truck side location.
top left of pulsar is angled up, rotating on the axis of the single bolt side.........
remove all three bolts.
-insert the first bolt into the bolt hole on the side with only 1 hole.
-Pivot the unit on the bolts axis, upwards, until the bottom Pulsar/PCM bolt hole lines up with the top Truck-side screwhole
Ok great thanks, I will reorder the edge pulsarmy truck had the same lines running in that area.
the right harness latch will be in close quarters but i dont recall any contact.