Halo's and C-bars

[DonnyP]

Has anyone here install Diode Dynamics Halo's and C-bars on their projector headlights?

I'm looking to mount mine but can't quite grasp the best of going about doing it. Getting them lined up around the shroud itself is a bit goofy, along with the c-bars.

How did you attach them, fishing line or beading wire?

Any close up pics of how you drilled the holes for the wires to run and how you mounted your halo's would be awesome.

This is the last thing I need to do and then I can seal up my headlights.

 

[OC455]

There's a video from The Retrofit Source and they used a push pin to make the holes around the shroud to put the halo wire through.

 

[DonnyP]

I’d be using 26 gauge bead wire. It is super tiny. I bought a dermal with special bits to make the holes for it.

I just don’t want to drill in wrong spot and not have halos and bars hold correctly or be able to see the holes.

Same goes for the holes for the wires.