Led question

[blackout11]

Ok got them in my turm signal my brake/parking/tail /turn signal work great but why the F do they flash so quick when i use turn signal.

 

[BigH0ss]

Get a relay in there! Or change out the flasher.

 

[blackout11]

Umm should not have to do either they are 3157 led bulbs should work they are plug and play

 

[Stangshcky12]

You need a resistor. Even though They just plug in the LEDs pull so little current that the trucks computer thinks the bulb is almost burn out. It's supposed to be a warning that your lights going to burn out soon

 

[Stangshcky12]

Something like this Recon Accessories: Part # 26420 - LED Light Bulb Load Resistor Kit

 

[The Assassin]

^^^this. It's called hyper flash. As stated, LED's draw very little power, thus the OBD thinks a light is on it's last leg.

 

[EJM05]

^that!

 

[blackout11]

Would i need 4 or 2 or what lol more money and more waiting sigh.And how are they spliced in i see 1 wire and my signal bulbs have 2 would i need 4 1 for each bulb or what never hooked them up not sure how they work.

 

[blackout11]

Never mind found it

http://www.superbrightleds.com/pdfs/load_resistor_info.pdf

 

[blackout11]

Or i could get one of these instead of splicing into all my wires




http://www.superbrightleds.com/cgi-...DispPage&Page2Disp=/specs/2-3pin_flashers.htm

 

[0212353]

Or i could get one of these instead of splicing into all my wires




LED Flasher Units FL2-RED & FL3-RED specifications

Computer controlled lights...........no "flasher".

Just splice those in, they work great!

 

[blackout11]

Computer controlled lights...........no "flasher".

Just splice those in, they work great!

Ya just popped the hood lol found that out ahh not badd at 5 bucks each halos will be in monday should have the lights done soon

 

[blackout11]

Ok which ones do i need

6 Ohm, 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb (2 Amp load). Leads are 12 inches long.

25 Ohm, 25 Watt resistors can be connected across marker lamps to simulate the load of a regular filament bulb. Leads are 12 inches lon

 

[blackout11]

Bump which one do i need

 

[blackout11]

click those links they are 5 bucks apeice but there are 2 different ones dont know which one i need they have different ohms

2010 Dodge Ram-pickup With-4-headlamp-system LEDs

to the right it says flashers and resistors they are on the bottom on that page just not sure which i need cause both have different ohms and watts

 

[blackout11]

Do i need 2 or 4 i have the leds in my front turn signals and rear brake/turn signals

 

[quietpeen]

what did you decide to get?

 

[0212353]

50w6ohm

you need them on any that act as a turn signal and parking bulb.

 

[blackout11]

50w6ohm

you need them on any that act as a turn signal and parking bulb.

Thanks jj ordering now

 

[tobyjohnson11]

I am thinking about putting leds in all my exterior lights too. So what exactly did you get?