Looking for tips on running my subs.

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

justin13703

Senior Member
Joined
Oct 15, 2014
Posts
1,174
Reaction score
394
Location
MD
Ram Year
2008
Engine
Hemi 5.7
Just run it under the trim that holds the carpet down. And go from the deck/battery to the amp, not the other way around
 
OP
OP
Repla_Skillz

Repla_Skillz

Senior Member
Joined
Jun 20, 2012
Posts
108
Reaction score
3
Location
Warburg, Alberta, Canada
Ram Year
2004
Engine
5.7L Hemi
No I mean I'm looking for the best way to run everything up behind and to the deck, I don't know which will be the easiest way to get behind all the console.
 

DTECH

Member
Joined
Aug 3, 2014
Posts
41
Reaction score
6
Location
Lancaster CA
Ram Year
2006
Engine
Hemi 5.7
do you have an after market deck or stock..once you remove the deck and trim around the heater controls you can fish all the wires under the dash to the drivers kick panel.. the trim piece by the e brake can pul off and you can continue to run the wires to the rear.. power wire can go through and existing grommet in the firewall on the drivers side...
 

DTECH

Member
Joined
Aug 3, 2014
Posts
41
Reaction score
6
Location
Lancaster CA
Ram Year
2006
Engine
Hemi 5.7
the amp can ground using the bolts that hold the seat frame down..just makes sure you sand away any paint on the surface to allow clean contact with the ground..
 
Back
Top