colport833
Member
- Joined
- Nov 24, 2013
- Posts
- 98
- Reaction score
- 41
- Location
- Ontario
- Ram Year
- 2022 Ram 1500 Classic
- Engine
- hemi
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I did not use anything yet
My bad. . .
I'm having a friend print some up 100% infill, and yes I do believe it is out of pla. Which should be fine.
Halogen bulbs get a lot hotter than the driver on an led, need the cover to keep out the moisture I thought the one cap being almost all the way on would be good enough it is not.
No...my guy used PETG? thats all I knowYou didn't use PLA did you?
I might have guy make groove for blue ring a tad deeper...You should sell those, I haven't found one that actually fits right...
Its from Cults3DDo you have a file for them? I'm struggling with the same issue
PLA is the "easiest" to print, but basically has the temperature range of a late 2000's Honda Civic Sunvisor.No...my guy used PETG? thats all I know