Increase Throttle Response

USPatriot1776 · Jan 31, 2024

Nick@GotExhaust said:
I do not know for sure but I would assume it does as it intercepts the signal and adjust it. Only 1 way to find out LoL

Haha probably way too sensitive, might have to change back to 5 and change the acceleration angle back to 200 /240 degrees

kstill · Feb 28, 2024

USPatriot1776 said:
If you want to emulate what a pedal commander does and improve your throttle change two settings in AlfaOBD:

To Change go into AlfaOBD and follow the steps below:

Body Control Module -> Diagnostics -> Car Configuration Change

ECUConfig14 /Acceleration Threshold: Filter Off

ECUConfig14 /Acceleration Factor: Filter Off

This made a huge difference in my throttle response. I've seen a few people debating whether it actually does anything but I can confirm that if you set it to those settings you will feel a difference in throttle.

I really like this setting. Thank you. It feels like my peddle is connected to my throttle with a cable. There is no lag from when I press the gas peddle and the throttle opening up.

Hemi395 · Feb 28, 2024

I looked at this on my 2013 and I don't see those listed....

kstill · Mar 1, 2024

I have driven my truck with these settings all week. I am just cautious with my peddle, but I still like this setting. The peddle is there if I need it.

WWlorodd1 · Mar 1, 2024

Forgive my ignorance hear but what is this AlfaOBD you guys are speaking of? Is this only for new trucks?

reddawg67 · Mar 2, 2024

Alphaobd is the program that allows you to make changes to the bcm like a dealer does, to add features to your truck after you have added the necessary part for the feature to work. Like adding heated and cooled seats or the global window down features just a couple myself i have added heated and cooled seats ATC (automatic temp control) remote start (John Lance off fb )added Bluetooth hands free phone and audio controls. Also upgraded to the UAQ carplay radio from the ra1 i had a bearbones 2017 ram 1500 express which is now relabeled THE EXPRESSplus lol Also Alittle plug for @Mpgrimm2 of M2mods Assisted with all the harnesses i needed for it all to work and some great customer service .

reddawg67 · Mar 2, 2024

Thread 'AlfaOBD'
https://www.ramforum.com/threads/alfaobd.123982/

WWlorodd1 · Mar 16, 2024

USPatriot1776 said:
If you want to emulate what a pedal commander does and improve your throttle change two settings in AlfaOBD:

To Change go into AlfaOBD and follow the steps below:

Body Control Module -> Diagnostics -> Car Configuration Change

ECUConfig14 /Acceleration Threshold: Filter Off

ECUConfig14 /Acceleration Factor: Filter Off

This made a huge difference in my throttle response. I've seen a few people debating whether it actually does anything but I can confirm that if you set it to those settings you will feel a difference in throttle.

I have the Windows version of AlfaOBD I cant find those settings for a 2011

RamDiver · Mar 16, 2024

WWlorodd1 said:
I have the Windows version of AlfaOBD I cant find those settings for a 2011

Look in here;

.

WWlorodd1 · Mar 16, 2024

I dont see that even when I try typing acceleration.

WWlorodd1 · Mar 16, 2024

Is it because its a 2011?

WWlorodd1 · Mar 16, 2024

Anyone have a list of things I can do with AlfaObd on a 2011?

RamDiver · Mar 17, 2024

WWlorodd1 said:
Is it because its a 2011?

This option must not be available for your truck year.

WWlorodd1 said:
Anyone have a list of things I can do with AlfaObd on a 2011?

What happens if you click in the find setting box?

On my '21, a window pops up and I can scroll through a large list of options.

.

Hemi395 · Mar 17, 2024

Sounds like the older trucks don't have this setting. My 2013 comes up with nothing if I type "accel", I have the Android version

PaleFlyer · Mar 21, 2024

NCRaineman said:
I like Pedal Commander for its ability to activate and deactivate with the push of a button. I enjoyed having it on Sport mode when I drove the truck, but now that my wife is the primary driver I have it deactivated for her because she doesn't care about acceleration or throttle response. If I do drive it somewhere I can turn it back on easily.

Oh... Good point... I need to figure out how to tie this to almost a "red key" situation...

She does NOT need faster response...

I want...

PaleFlyer · Mar 21, 2024

USPatriot1776 said:
May just be that some trucks don't change as much, was debating getting one of those but from what ive heard they can cause issues on the CAN bus over time. My next step will be an ECM upgrade, either a pulsar or a diablo one.

Did some research into Pulsar, apparently they are pretty good, until they brick themselves/your ECM...

Risk with having something "futz" with the signals AT the ECM, and they are not much cheaper than just unlocking your ECU, and doing a proper Diablo/HPTuners. (I have an '18, so I have to unlock before I can do anything)

metalchewy · Mar 21, 2024

WWlorodd1 said:
Anyone have a list of things I can do with AlfaObd on a 2011?

AlfaOBD Support For 06~12 Rams

Inspired by the 4th Gen DIY AlfaOBD thread I wanted to call on any knowledge for the 2006 through 2012, in particular the cummins 6.7. I mainly bought the app for Daytime Running Lamps, but I'm getting nowhere. I've been in conversations with a couple of forum members who have later models. It...

www.ramforum.com

I could find nothing related to Pedal, Acceleration,or threshold for my 2010, unless it's called something cryptic, or one of the general options in car configuration I do dont think it is avaliable for 2012 or older CGMs

Edit: autocorrecvt changed don't to do in my post. Corrected now.

04fxdwgi · Mar 22, 2024

I did the accel changes to the BCM on my '16. Just driving like an old fart, there seems to be a little difference. But if get "aggressive" with the pedal, there is a huge boost in response. Me likey.

Like stock when parking, is a good thing.

PaleFlyer · Mar 22, 2024

Did the change when I left work yesterday, my '18 seemed more responsive this morning. Less of the "I need a second to get all this steel moving" from a standstill.

I thought it was just the mass of the engine/crank/w/e took a second to get moving before it could provide more power to the tranny, not a stupid S-Curve on the pedal.

Black-Wolf · Mar 22, 2024

I removed my PC back in December due to the cold seemingly causing glitches in my system and the truck kept going into limp mode. After removing it, I did some research, and found out that it was probably caused either by me messing with it while driving, or by the cold causing the connectors to separate ever-so-slightly as to cause voltage changes as the heat blew on them and they warmed up. In anycase, I decided to leave it out for the time being, but I did find the OP here, and made the mod using Alpha... Yesterday, I decided what the heck - it's warming up - so I reconnected my PC into the system - and if you think the PC was good by itself - damnnnnn - YOU NEED to make the mod AND use the PC at the same time! In Sport mode, it's like driving in Sport+... I haven't even tried Sport+ at this point... Actually a little scared to.

If you do this - please post the results - 'cause I'd like to know if I'm just crazy or if it really is like a demon being unleashed!

Increase Throttle Response

Member

Junior Member

Senior Member

Junior Member

Member

Senior Member

Senior Member

Member

Senior Member

Member

Attachments

Member

Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Similar threads

Forum statistics

Share this page