jws123
Senior Member
Picked up a 2006 ram 1500 4.7 150k 2 door 2wd lowest model crank windows ect. It does not start it was very low on oil almost none in it they said it just died on them turns over and sounds fine but doesnt even try to start good fuel pressure to rail. I plugged in my scanner and here are the codes i get.
Transmission control system Mil
u110z Lost communication with SCM steering control module can-c.
u0114 lost communication with Final drive control module.
u0ff4 u0ff3 u0ff2 refer to manual
Clearly some electrical issues going on here will any of these make it not run? All suggestions appreciated going to start tracing wires connectors ect I already checked fuses
Transmission control system Mil
u110z Lost communication with SCM steering control module can-c.
u0114 lost communication with Final drive control module.
u0ff4 u0ff3 u0ff2 refer to manual
Clearly some electrical issues going on here will any of these make it not run? All suggestions appreciated going to start tracing wires connectors ect I already checked fuses