I got a gator on my truck ('17) that was on it when I bought it
I have no reason to believe it wasn't installed in early '17 when the p.o. picked it off of the lot
Best I can tell it does all it needs to do
(Now, if i were to design a folding cover there would be some sort of frame that allowed me to lift it up on the leading edge behind the cab, instead of always having at least one panel down on the bedrail, but I digress)
Now, where I was going with this is the following, one of the clamp sections broke recently
This is the plastic part that the clamp slides in
We're talking work truck here and something...it gets used as a work truck, so it may have been slammed and jammed and crammed and of my goodness I'm stuck in a rap
So, piece broke, so I go trying to call...would t you know it, there is no phone number for Gator tonneau covers, they all lead to 'American Trucks'
So I gave them a call
15 minutes and 20 dollars later I got two new clamp sections in the mail, that's a good thing
I have a ‘17 Sport. Came with a spray in liner as an option not sure what the dealer would have applied. I’ve had lumber, firewood and gravel as well as a quad in the back and it’s stood up perfectly. As far as a cover, mine has The Lo-Pro by Truxedo. So it mounts to the inside of the box rails instead of on top. It’s a soft roll-up and it’s worn beautifully. The only downside is that it doesn’t cover the 2 open stakes pockets at the back but I’ve still had almost no water in the bed even with a pounding rain.
They also make rubber covers that just snap in, in case you don't like the tie downs sticking out