bedliner screws?

[Saetun]

Picked up an OEM drop in liner. Looks like there are screw holes near the rear to hold it in place. Anyone know the size of the screws or if they are avail from anywhere? thx

~Sae

 

[BlackedOutHemi]

I'm not sure the size, when I pulled them out to take out my tailgate handle I'd guess about an inch, but that's not for sure. ANd they're like torx

 

[300MAG]

You reuse the existing screws from the tailgate access panel.

Sent from my GT-P7510 using Tapatalk

 

[quietpeen]

I think he is talking about the vertical sides by the tail lights....not the tailgate

I would say the dealer would be your best bet.

 

[HemiBabe]

I went and looked at mine and my drop in bed liner doesnt even have any screws in there lol weird but it aint comin out haha maybe you dont need any... you could also check LMC they have a lot of the OEM scews, nuts and bolts

 

[OlDirtyJohn]

You reuse the existing screws from the tailgate access panel.

Sent from my GT-P7510 using Tapatalk

^this

 

[Saetun]

I think he is talking about the vertical sides by the tail lights....not the tailgate

Yep, looking for the screws that fit here!


Anyone know if they are the same as the tailgate? I'll rifle through my LMC catalog as well.

 

[quietpeen]

Yep, looking for the screws that fit here!


Anyone know if they are the same as the tailgate? I'll rifle through my LMC catalog as well.

truthfully i think they are different. Its been too long since I took the liner out of my old truck

 

[BlackedOutHemi]

They are. I took a look at mine. There's two screws up against the tailgate on either side. Just Phillips heads that are flared out. Don't know size yet.


Sent from my iPhone using Tapatalk