Finally Done Zone 6" with 37s !

[Chief_6.7]

Damn... I am looking at lifting it 6 inch and maybe 37 buy without bils i will need quit a bit of triming.

Not if you stay with oem wheels. I’m running a 6” pro comp with oem wheels and 35s but I’ve done some measuring and I can clear 37s with maybe and I mean maybe some minor trimming on the front lower valance. I’m also running 1.75” bora spacer to stick them out a little more

 

[Ohio5pt7]

How much did the 37s effect power?

 

[S0CAL]

How much did the 37s effect power?

For me, not much. I have 4.56 gears. Still a crapload of lowend torque. Of course headers help

 

[Maligator]

How much did the 37s effect power?

For me with the 3.21 gears it did make it a bit sluggish but not so bad that it bothered me. It still had more than enough power to move the 37s

Sent from my Pixel 2 XL using Tapatalk

 

[Algunz]

For me with the 3.21 gears it did make it a bit sluggish but not so bad that it bothered me. It still had more than enough power to move the 37s

Sent from my Pixel 2 XL using Tapatalk

Sorry if you already answered, but are those stock UCAs?

 

[Maligator]

Sorry if you already answered, but are those stock UCAs?

They were mevotechs

Sent from my Pixel 2 XL using Tapatalk

 

[Aymchayer]

it all depends on the wheel width and offset

So what you think will be the right size for no triming and 37

Thank you!

 

[Chief_6.7]

So what you think will be the right size for no triming and 37

Thank you!

You can run a 37 with a 6” lift with stock wheels.

 

[Aymchayer]

You can run a 37 with a 6” lift with stock wheels.

Without any triming ?

 

[JB1]

Also a 20x9 with 0mm offset according to the instructions. Mine are -12mm and I had to trim my front lower plastic airdam corner but no metal, has plenty of room near the fender

Similar discussion

https://www.ramforum.com/threads/6”-lift-37s.115614/#post-1661828

 

[Chief_6.7]

Without any triming ?

Yes sir you are correct without any trimming. I have a 6” lift running stock 20” wheels and bora 1.75” spacers and I clear 37s no rubbing. I currently have 35s but I did try on the 37s to see the fitment and they look a lot better on the truck. When my current 35s wear out I’m sure I’m gonna go 37s since now I know for sure they will clear

 

[Aymchayer]

Yes sir you are correct without any trimming. I have a 6” lift running stock 20” wheels and bora 1.75” spacers and I clear 37s no rubbing. I currently have 35s but I did try on the 37s to see the fitment and they look a lot better on the truck. When my current 35s wear out I’m sure I’m gonna go 37s since now I know for sure they will clear

Good thank for the info I am looking forward to do the same with 37 12.50 20 !