spacedace
Junior Member
Here’s an interesting one. Before we get too deep yes I installed two new flashing units.
The hazards operate correctly when the column button is depressed.
The turn signals work fine as well.
However, when I pull the lights switch to half and full position, both green arrows illuminate on the dash. If I put a blinker on it still works.
I don’t drive this truck much as I have been repairing it little by little. It was given to me and needed tlc.
I’ve also notice that the high beam light comes on when I pull the lights switch to halfway. When full I am able to toggle the high beams as normal.
What they heck is goin on here?
The hazards operate correctly when the column button is depressed.
The turn signals work fine as well.
However, when I pull the lights switch to half and full position, both green arrows illuminate on the dash. If I put a blinker on it still works.
I don’t drive this truck much as I have been repairing it little by little. It was given to me and needed tlc.
I’ve also notice that the high beam light comes on when I pull the lights switch to halfway. When full I am able to toggle the high beams as normal.
What they heck is goin on here?