Wts Marco 1/2 impact wrench and BluePoint Mini angle grinder

[Throwin Plugs]

Used for 2 years in a diesel shop then sat in my toolbox for a few years. Just oiled and tested them, run as good as they did when I was using them every day.

The torque wrench is a BEAST. Has a rubber cover on it.

Angle grinder is awesome for tight spots. Used to use it to clean up edged when doing kingpins. Uses twist in abrasive discs.

Wrench is gonna be $220 shipped

Grinder is gonna be $50 shipped

Paypal only please.

Thanks!

 

[caulk04]

There doesn't seem to be any seller/buyer feedback around here, but I'll at least put in my $.02. Good seller here!

 

[WY.Ram]

Any idea what the torque spec is for the 1/2? I have a milw 3/4 inch claims 1400ftlbs loosening but it's dreaming I think. I haven't run up against anything it couldn't handle but it's gonna happen, for one it's pretty big and can't get it everywhere, even the 3/4 to 1/2 adapter adds enough length that I've to figure something else out. Any way I'll have my compressor up in couple months, this will be a great addition. PM gonna be sent.

'16 Wagon Greene tune feed'n & fire'n 6.4L with 6spd • 5.13 AAM, 37" KM3, -12mm Fuels • Thuren Overland, DOR, Purple Cranium • CAI, ARH, Solo Mach44 • z36, EBC • Custom vinyl AVS, 4% tint • Morimoto, Rigid, Diode Dynamics • AlfaOBD, Diablo, Nanny Kill, Locker bypass •.................

 

[Throwin Plugs]

There doesn't seem to be any seller/buyer feedback around here, but I'll at least put in my $.02. Good seller here!

I appreciate it!

Any idea what the torque spec is for the 1/2? I have a milw 3/4 inch claims 1400ftlbs loosening but it's dreaming I think. I haven't run up against anything it couldn't handle but it's gonna happen, for one it's pretty big and can't get it everywhere, even the 3/4 to 1/2 adapter adds enough length that I've to figure something else out. Any way I'll have my compressor up in couple months, this will be a great addition. PM gonna be sent.

'16 Wagon Greene tune feed'n & fire'n 6.4L with 6spd • 5.13 AAM, 37" KM3, -12mm Fuels • Thuren Overland, DOR, Purple Cranium • CAI, ARH, Solo Mach44 • z36, EBC • Custom vinyl AVS, 4% tint • Morimoto, Rigid, Diode Dynamics • AlfaOBD, Diablo, Nanny Kill, Locker bypass •.................

Matco's website states 1600 ft/lb breakaway which id believe. There was nothing it couldn't handle that didn't need a 1" gun instead. Its a powerhouse for sure. PM answered.

 

[Throwin Plugs]

Sold to YRam!