7mm spacers

[bryan28]

I would like to know if I can safely run a factory 20x9 wheel with 7mm (.28") spacers. Will I have enough thread on the lugs to properly secure the wheel and not worry about the wheel coming off? Another member has confirmed a 5mm spacer works fine but I want to know specifically about a 7mm spacer. Thanks

 

[stimpy433]

Check out this thread, looks like you can go up to 10mm spacers: https://www.ramforum.com/threads/half-inch-wheel-spacers.109654/#post-1584935

 

[KeepRight]

Look up hub centric spacers... I would not go with lug centric.

Sent from my SM-N960U using Tapatalk

 

[Dinky]

Measure the stud diameter. Times that by 1.5 and that is the max holding strength. Anything over that number wont hold any better. less will be weaker of course