Front stake pocket caps?

[mjscharlotte]

Hey guys,
I just took off an old tonneau cover and replaced it with the Undercover TriFold. My old cover covered the factory bed rails and this one doesn't so I want to plug the holes in the bed rails. I can find rear hole caps but can't find anything for the front holes. Does anyone know if they are the same size as the rears? If not, where can I find them. Thanks

 

[michael harpe]

i believe they are the same. they look the same on my 18 pw. have you tried seeing if the rear ones will fit the front? or have you not ordered them yet?

 

[mjscharlotte]

i believe they are the same. they look the same on my 18 pw. have you tried seeing if the rear ones will fit the front? or have you not ordered them yet?

I haven't ordered them yet - I was going to order all 4 if they will fit. My local Dodge Dealership is about as much good as a screen door on a submarine. I may try and call another dealership and see what they say.

 

[michael harpe]

I haven't ordered them yet - I was going to order all 4 if they will fit. My local Dodge Dealership is about as much good as a screen door on a submarine. I may try and call another dealership and see what they say.

check out one of the mopar parts dealers online. they should be able to tell you what part numbers are for front and rear. also they are about 15% over cost compared to dealership markups.

OEM MOPAR Parts Online | Mopar Factory Parts

 

[Ricks Ram]

I haven't ordered them yet - I was going to order all 4 if they will fit. My local Dodge Dealership is about as much good as a screen door on a submarine. I may try and call another dealership and see what they say.

Contact Benny @AllMoparParts.com in the vendor section of the forum. He is extremely knowledgeable and will get you the part #s you need. They also have very competitive prices. He's kinda the go too around here for factory parts.

Sent from my SM-G981U1 using Tapatalk

 

[michael harpe]

I checked them out when I needed parts and found the site I listed to be a bit cheaper. Compare both I’d say.


Sent from my iPhone using Tapatalk

 

[BWL]

They are both the same size. I put tie downs in my stake pockets to fill the holes instead. If it has the plastic rail caps they'll need trimming to fit, but the pockets themselves are the same size.