frankinstienbuild
Junior Member
I have a 2006 dodge ram 1500 megacab 4x4 built on top of the 2500, my truck was on the back of a tow truck and the driver left my transmission in park with the front wheels on the ground and tried to tow down the highway the wiring harness got snatched by the front drive shaft and the drive shaft kicked my fuel line and punched a hole through the floor and blew apart the transfer case,,. Everything has been replaced and I have the red lightning bolt on my dash and so I put a new throttle body on and a new apps gas pedal sensor and a new crank sensor and cam sensor still no throttle response at all,. Only dtc codes is biometric pressure, heated o2, and throttle switch e low input and secondary voltage b low input,. And now I get a cam code, but the sensor is brand new, also have a new battery rated at 1000 ca and 800 cca, also my truck has a new rebuild kit all the way around the motor and also 8 new injectors but still sounds like a misfire cause sometimes I'll get a code for cyl, 2,4,6
I'm almost ready to try reprogramming the computer or pulling ç2 to pinout chase wires for a chase of any wire breaks, truck wants to idle but just stalls out and start back up rev up and stall out it's trying to idle between 300-500 rpm also has a new air filter and ac compressor and water pump and alternator and starter, and transmission rebuild and new power steering pump and new belt and new spark plugs damn near an entire new truck but I'm lost figuring out the throttle issue..
I'm almost ready to try reprogramming the computer or pulling ç2 to pinout chase wires for a chase of any wire breaks, truck wants to idle but just stalls out and start back up rev up and stall out it's trying to idle between 300-500 rpm also has a new air filter and ac compressor and water pump and alternator and starter, and transmission rebuild and new power steering pump and new belt and new spark plugs damn near an entire new truck but I'm lost figuring out the throttle issue..