ldiaz
Junior Member
Hi everyone, I need some help. I have a 2003 2500 dodge ram that I just installed a new transmission, but it doesn't want to move unless I put it in 4 high then it moves. What could be wrong?
Truck wont move!!
- Thread starter ldiaz
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Ricktara
Member
I don't see any comments to help you yet. You have probably gotten help elsewhere by now but my thoughts are that the transmission doesn't care if you are in 2 Ed or 4wd. You most likely have an issue with the transfer case, but you can't rule out the rear differential could have a stripped gear. Good luck.
- Joined
- Aug 2, 2018
- Posts
- 25,912
- Reaction score
- 56,717
- Location
- Central Texas
- Ram Year
- 2019 Bighorn, 4 X 4, 3.21 rear, Bright Flame Red Pearl Coat, Mopar tonneau cover,Westin Bed rug
- Engine
- Hemi 5.7, Non E Torque
Sounds like a Transfer case engagement issue, but U need a person who is a Gearhead to help U out on this one.
fireflymedic
Senior Member
I would jack up the rear end so back tires are off ground and spin rear tires by hand and see/hear if rear end seems ok. Pay close attention to rear drive shaft too. I mean it's possible they forgot to connect it or something.
