61N150W
Senior Member
Finally did the conversion today. I had been using my UAS with the infotainment bezel.
Install was in a 2014 Bighorn 1500 (Canadian) using HVAC Module 68268186AA. I have full heat and movement of the blend doors.
I did however use a dual zone bezel simply because I had been on the search for a single zone with no luck and gave up. At initial boot-up, it was trying to offer me both zones but wouldn't allow me to increase the temperature (would auto drop to max cold). I shut it off and the screen stayed lit but blank for about 10 mins, even after I left the truck. Once it shut off completely, I started it back up and the controls were now single zone and temp operated as intended. [emoji106]
I do now have a CEL, but haven't looked into it. May have been from pulling the negative battery cable.
Sent from my SM-G955U using Tapatalk
Install was in a 2014 Bighorn 1500 (Canadian) using HVAC Module 68268186AA. I have full heat and movement of the blend doors.
I did however use a dual zone bezel simply because I had been on the search for a single zone with no luck and gave up. At initial boot-up, it was trying to offer me both zones but wouldn't allow me to increase the temperature (would auto drop to max cold). I shut it off and the screen stayed lit but blank for about 10 mins, even after I left the truck. Once it shut off completely, I started it back up and the controls were now single zone and temp operated as intended. [emoji106]
I do now have a CEL, but haven't looked into it. May have been from pulling the negative battery cable.
Sent from my SM-G955U using Tapatalk