help needed

  1. Zera

    Sticking at 2,250 rpm whenever I accelerate fast.

    Need some help figuring out what's going on. I have a '97 12v and if I accelerate up to anywhere from 2,100-2,300 rpm my throttle decides to stick there until I slap it in neutral & keep revving it until it releases. Anyone have any idea what could be causing this issue?
  2. W

    P0303 code

    Alright. About a month ago my 1998 ram 1500 popped up with a p0303 code. I got this code a couple years ago, cleared it and it never came back until a month ago. At first I thought it would be on the ignition side of things. Replaced spark plugs, wires, distributer cap, rotor and coil wire. They...
  3. doughboy95

    03 1500 p0601 problems

    Hello i been trying to fix this P0601 it saus a memory checksum error and trying to make absolutely sure its the pcm cause not cheap. My check engine lights on and my seatbelt and airbag n which when i start it my airbag blinks one then stays solid whether i have it turned on or not. The sensor...
  4. C

    Trans temp 2013 6speed

    Hello all, this is my first post. I have a 2013 1500 4x4 with a 6 speed and I’m seeing 200+ degrees empty on the trans. I’ve seen posts about people staying considerably cooler even when towing. I’ve flushed the transmission at 110k and replace the trans solenoids and filters and atf 5k miles...
  5. JD522

    Lift Guidance Needed

    I think I am finally ready to order stuff to lift my 2015 Ram 1500 Bighorn crew cab, 6'4" bed. Its about 2 3/4" high in the rear. I've seen a truck posted by BowersFJ that is the setup I had in mind. I plan to get the following: Zone 4/3" lift with Fox rear shocks Bilstein B8 5100 front...
    • JD522
    • Thread
    • advice help needed lift
    • Replies: 22
    • Forum: Lifted
  6. Marrapode

    Will this combo work?

    I'm not the best when it comes to wheel and tire combinations. Had a piece of rebar blow through my tire on the highway today, so I figured it's time for an upgrade now haha. If someone could help me out that'd be great! Thanks MOTO METALMO962 Size: 17x10 Offset: -24mm Backspacing: 4.606" Bolt...
  7. I

    Rear caliper

    We bought a 2021 Ram Built to Serve less than a month ago. Brake light came on Thursday. Dealership says rear caliper broken. My question is how does this happen? ALSO, we are in Texas and as you know it has been cold AF the past week.
    • Inkedtx
    • Thread
    • 2021 ram 1500 brake fluid built to serve help needed rear caliper
    • Replies: 2
    • Forum: Exterior
  8. X

    2013 RAM 1500 Losing power after Warm up

    Hi guys, I'm running into an issues for the past few days where I'll crank my truck up and let it idle and warm up for around 15-20 minutes in the morning before work. Water temp is good, Oil temp isnt too bad and even trans gets a little radiated heat into it. The problem is after taking off...
  9. B

    Truck randomly won't start or shuts off while driving

    Hey guys I really hope someone here can help me out I'm in a pickle. I have a 2019 rebel with pretty much every option and it was the first new vehicle and the most expensive vehicle I have ever purchased and boy has it been a nightmare... So the issue is sometimes the truck doesn't start it...
  10. C

    Need Help 68 D100

    Bought a 68 D100 in Texas recently, advertised as a 318. The guy did alot of jacked up work to it but it seemed like a fixable nightmare. But today I've run into the problem of, I no longer believe its a 318 or at least not an original 318. The new valve covers dont fit. The radiator set up is...
  11. Dingalinger

    COOLANT ALL OVER

    Hey guys, I just got into rams and I love my 5.7 but I was driving and made it home to steam coming out of my engine bay with coolant everywhere but I dont know what the appropriate course of action is right now, what are some common problems that might help me diagnose my truck it is a 2014 ram...
  12. nld1299

    Tow Mirrors HELP!

    Hey y’all, I have a 2017 Ram 1500 Tradesman and I’m trying to find some tow mirrors for the truck but I can’t find them anywhere! I don’t have all the bells & whistles so no turn signal light and no puddle light. I’ve read on here that you can get the codes for those lights flashed on the truck...
    • nld1299
    • Thread
    • help needed puddle lights ram 1500 tow mirror pair
    • Replies: 12
    • Forum: Exterior
  13. N

    Need help with quick FOB question

    Key fob all of a sudden stopped working outside the vehicle. Replaced battery and still same issue. Any suggestions? 07 Ram 1500 Laramie
    • NavyFireMedic
    • Thread
    • fobs not working with new batteries help needed pita
    • Replies: 8
    • Forum: Tech Info
  14. NickyLenz

    WHERE DO I FIND REPLACEMENT LIFTED PARTS???

    I've been losing my MIND trying to find replacement Front sway bar end links for my 2011 Ram 1500 4x4 with a 4" rough country lift, and even though i'm trying my hardest to replace parts as they go with ANYTHING BUT RC, i cant even find just the end links even through rough country. Can someone...
    • NickyLenz
    • Thread
    • 4" lift help needed lifted lifted ram parts replacement sway bar links
    • Replies: 3
    • Forum: Lifted
  15. A

    Oil leaking help

    Ok, so I don’t know much about fixing trucks but I just got a 1996 Dodge Ram 1500 5.9 and trying to learn. I have a major oil leak and trying to figure out we’re it’s all coming from. The oil pan is soaked of oil but it also looks like it’s coming from above so the oils pan may be fine. The oil...
  16. J

    Ram 2500 problems lol

    Was doin about 60 floored it and once the engine hit 4K rpm it won’t rev higher and the engine sputters in a way if ya know what I’m saying it’s also limited to 4K rpm in every gear and is still driveable any help needed ASAP please or other things to try other than buying a Cummins lol Thank...
  17. R

    Brakes

    I was wondering about doing brakes. When sliding the new pads in is it ok if they are tight against the rotor or do they have to have a space and be kind of springy. I placed mine in and they are tight against the rotor so I stopped in case this was incorrect. Any help will be greatly...
    • Ryley
    • Thread
    • brake pads brakes diy help needed
    • Replies: 4
    • Forum: 4th Gen DIY
  18. S

    Power steering pump problems 03

    Hello, I'm new to this forum, my names shawn nice to meet you guys! That being said I've searched everywhere for a diagram to figure out if I have a valve put in correctly on my power steering pump to no avail. I had a leak on my high pressure hose coming from the power steering pump...
  19. scooterderek

    6” superlift and bilsteins questions

    So I just installed the 6” superlift on my 2009 1500. I have my bilsteins at the setting above stock which is .7” . And even with the included diff drop bracket and bils at .7 my cv angles are pretty terrible AND my truck still has 1.5” of rake. I really want to bring my bilsteins up a little...
    • scooterderek
    • Thread
    • 1500 help help needed lift kit lifted superlift
    • Replies: 9
    • Forum: Lifted
  20. Liam Gracey

    Heat working on passenger side but not on the driver side.

    Hey there everyone, I have a 2013 ram 1500 reg cab and I had an issue last year and again this year with my heat not working on the driver side of the truck, it blows like warm air. I have flushed the heater core and changed the thermostat in the truck as well as new coolant. Both lines going...

Latest posts

Staff online

Members online

... and 16 more.
Total: 1,276 (members: 66, guests: 1,210)
Robots: 1,378

Forum statistics

Threads
195,400
Posts
2,869,746
Members
156,068
Latest member
shadow338

Share this page

Top