Well I finally went out and purchased a Foxwell NT650 Elite scanner. I was told by the company that this particular scanner will bleed the ABS pump/valve side of the system. It also says I must do a manual bleed first. My son and I did the manual bleed first and did get some air out of the system. We then went onto the auto bleed part and followed the procedure. We got stopped at the point where the procedure should start the pump. It didn't, but instead told us there was no communication and I needed to check for a proper connection to the vehicle's DLC, that the ignition is turned on and the battery is charged. All that was checked (actually, we did this procedure 3 times). I did check the 3 fuses located in the fuse block near the battery... All were good.
Suggestions please!