AlfaOBD: Where do I find the Steering Angle Sensor (SAS) information?

[pope3909]

I have a 2014 RAM 1500 5.7 that I just replaced the clockspring on. I switched my old SAS onto the new clockspring and need to view the current angle and recalibrate it, but I've looked everywhere in the android app (v2.4.2.0) and can't find it.

 

[Leviwebb2]

I also have a 2014 RAM 1500 and swapped out the clock spring but more get the traction control light and a steering pull to the left at slower speeds. When I speed up the computer seems to accept that where I hold my hand straight, it accepts the straightness and stops pulling left. Dealer said it’s a bad clock spring again, or it was installed off center somehow. I bought AlfaOBD for computer and vLinker FS. Took a minute to figure out how to connect it to the truck but I managed to get everything to talk. My issue is that I don’t see where SAS recalibration is. I’ve gone through every many I believe. Anyone have any ideas?

 

[04fxdwgi]

As far as I see there is a "reset" for the steering angle located in the "Steering" function selection called "Clear Steering Pull Compensation"

and there are manual settings for + or - steering angles in "Car Configuration"