For those that have factory projectors that want these, here’s an easy conversion harness you can make. The headlights already come with one third of the parts- this little extension harness (circled)-
Here it is by itself- cut the yellow circled end off-
Here’s the 3157 bulb socket pigtails that goes into the socket holes on the new lights-
https://www.amazon.com/iJDMTOY-Pre-Wired-Harness-Repair-Replacement/dp/B01GP6B9WA/ref=mp_s_a_1_fkmrnull_1?keywords=iJDMTOY+(2)+3156+3157+Pre-Wired+Harness+Sockets+For+Repair,+Replacement,+Install+LED+Bulbs+For+Turn+Signal+Lights,+DRL+Lamps+or+Brake/Tail+Lights&qid=1553571390&s=gateway&sr=8-1-fkmrnull
And here’s the male projector harness mating connector (2 sets)(thanks for the link
@1500ram12)-
https://www.amazon.com/headlights-1J0973837-lamp-socket-Headlight-connector/dp/B07LD6C2R1?th=1&psc=1
And you’ll need two 10” lengths of 18awg wire with two female bullet connectors for the DRL wire (not sure what size, I had some red ones laying around that fit).
Then just crimp the appropriate male projector connector terminals on the ends of the wires (pay attention because some wires get small terminals and some get the large terminals), and insert them into the correct numbered pin positions.
Note: in order for the DRLs to function with this wiring method, the dedicated DRLs need to be enabled with the alfaobd. Otherwise, don’t pin the red wire into the projector connector, and use a relay harness to trigger them.